1.CONNECT GTS
Connect the GTS to the DLC3.
Start the engine and allow it to idle.
Turn the GTS on.
Perform the active test using the GTS.
2.INSPECT BRAKE ACTUATOR AND SOLENOID
Do not keep the motor and solenoid turned on for more than 5 seconds continuously. Allow intervals of at least 20 seconds between consecutive operations.
The active test for each solenoid operates for about 2 seconds and then automatically stops.
With the brake pedal depressed, perform the following operations.
Turn the "Actuator drive(RL)" on, and check that the pedal cannot be depressed further.
Turn the "Actuator drive(RL)" off, and check that the pedal can be depressed further.
Repeat the same procedures for the other wheels.