Immediately wash off any brake fluid that comes into contact with any painted surfaces.
If any work is done on the brake system or if air in the brake lines is suspected, bleed the air from the system.
1. FILL RESERVOIR WITH BRAKE FLUID
| *a | MAX Line |
| *b | MIN Line |
Fill the reservoir with brake fluid.
SAE J1703 or FMVSS No. 116 DOT3
Add brake fluid to keep the level between the MIN and MAX lines of the reservoir while bleeding the brakes.
47201
2.BLEED BRAKE MASTER CYLINDER SUB-ASSEMBLY
If the master cylinder has been disassembled or if the reservoir becomes empty, bleed the air from the master cylinder.
Using a union nut wrench, disconnect the 2 brake tubes from the master cylinder.
Slowly depress the brake pedal and hold it there (Step A).
Block the outer holes with your fingers, and release the brake pedal (Step B).
Repeat steps A and B 3 or 4 times.
Using union nut wrench, connect the 2 brake tubes to the master cylinder.
Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
3.BLEED BRAKE LINE
Bleed the brake line of the wheel farthest from the master cylinder first.
Add brake fluid to keep the level between the MIN and MAX lines of the reservoir while bleeding the brakes.
Connect the vinyl tube to the bleeder plug.
Depress the brake pedal several times, then loosen the bleeder plug with the pedal depressed (Step C).
At the point where the fluid stops coming out, tighten the bleeder plug, then release the brake pedal (Step D).
Repeat steps C and D until all air in the fluid is completely bled out.
Tighten the bleeder plug.
Repeat the above procedure to bleed the air out of the brake line for each wheel.
4.INSPECT FOR BRAKE FLUID LEAK
5.INSPECT FLUID LEVEL