Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE FLUID
RM19Y0E _54 Brake _002993 BRAKE SYSTEM (OTHER) _0015143 BRAKE FLUID A

BRAKE SYSTEM (OTHER)  BRAKE FLUID  REPLACEMENT  


CAUTION / NOTICE / HINT

NOTICE:

Immediately wash off any brake fluid that comes into contact with any painted surfaces.


HINT:

If any work is done on the brake system or if air in the brake lines is suspected, bleed the air from the system.


PROCEDURE

Hide 1. FILL RESERVOIR WITH BRAKE FLUID

a.
C152660C01
2,0.677 2.625,0.156 true 2.719,0.833 2.177,0.833 true 2.656,0.031 3.031,0.396 0.375,0.365 10 *a 2.792,0.75 3.292,1.229 0.5,0.479 10 *b
*a MAX Line
*b MIN Line


Fill the reservoir with brake fluid.

Fluid:

SAE J1703 or FMVSS No. 116 DOT3


NOTICE:

Add brake fluid to keep the level between the MIN and MAX lines of the reservoir while bleeding the brakes.



Hide 2.REPLACE BRAKE FLUID

a.
C152601

Connect a vinyl tube to the bleeder plug.


b.

Depress the brake pedal several times, and then loosen the bleeder plug with the pedal depressed (Step C).


c.

At the point where the fluid stops coming out, tighten the bleeder plug, and then release the brake pedal (Step D).


d.

Repeat Steps C and D until the new brake fluid comes out.


e.

Tighten the bleeder plug.

Torque:
Front Brake : 8.3 N*m (85 kgf*cm, 74 in.*lbf)
Rear Brake : 11 N*m (110 kgf*cm, 8 ft.*lbf)


f.

Repeat the above procedure to bleed the air out of the brake line for each wheel.


Hide 3.INSPECT FOR BRAKE FLUID LEAK