Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE MASTER CYLINDER(for LHD) › 2011.11–2015.08
RM19Y0E _54 Brake _002993 BRAKE SYSTEM (OTHER) _0015145 BRAKE MASTER CYLINDER(for LHD) A

BRAKE SYSTEM (OTHER)  BRAKE MASTER CYLINDER(for LHD)  DISASSEMBLY  


PROCEDURE

Hide 47202 1.REMOVE BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY

a.
C152683

Fix the brake master cylinder sub-assembly in a vise between aluminum plates.

NOTICE:

Do not overtighten the vise.



b.

Using a pin punch (5 mm) and hammer, tap out the ring pin.


c.

Remove the brake master cylinder reservoir sub-assembly and 2 grommets.


Hide 47230 2.REMOVE BRAKE MASTER CYLINDER RESERVOIR FILLER CAP ASSEMBLY

Hide 04493 3.REMOVE BRAKE MASTER CYLINDER KIT

a.
C152684

Push in the piston and remove the snap ring using snap ring pliers.

NOTICE:

When pushing in the piston, the fluid left in the cylinder may spatter.



b.
C152685

Push in the piston and remove the piston stopper bolt and gasket (w/o ABS).

NOTICE:

When pushing in the piston, the fluid left in the cylinder may spatter.



c.
C152686

Push in the piston and remove the straight pin (w/ ABS).

NOTICE:

When pushing in the piston, the fluid left in the cylinder may spatter.


HINT:

Use a piece of cloth to prevent damage to the straight pin.



d.

Remove the No. 1 piston from the master cylinder body by pulling it straight out.

NOTICE:

Do not scratch the inside of the cylinder body.



e.
C142055
1.083,1.938 0.76,1.458 0.76,1.458 0.646,1.458 true 1.833,1.396 2.219,0.781 2.219,0.781 2.438,0.781 true 2.521,0.698 2.948,1.063 0.427,0.365 10 *1 0.406,1.354 0.802,1.75 0.396,0.396 10 *2 2.75,2.125 3.177,2.469 0.427,0.344 10 A
*1 No. 2 piston
*2 Wooden block


Tap the flanged part of the master cylinder body against wooden blocks until the end of the No. 2 piston comes out. When the end of the No. 2 piston comes out, pull the No. 2 piston straight out of the master cylinder body.

NOTICE:

Do not scratch the inside of the cylinder body.


HINT:

Make sure that distance A, from the piece of cloth to the top of the wooden blocks, is at least 100 mm (3.94 in.).