04493
1.INSTALL BRAKE MASTER CYLINDER KIT
Fix the master cylinder body in a vise between aluminum plates.
Do not overtighten the vise.
| *A | w/ ABS |
| *1 | Pin hole |
| *2 | No. 1 piston |
| *3 | No. 2 piston |
|
Lithium soap base glycol grease |
|
Silicon grease |
Apply lithium soap base glycol grease and silicon grease to the rubber part as shown in the illustration.
Install the No. 1 piston and No. 2 piston onto the master cylinder body.
Install the pistons straight while being careful not to damage the inside of the cylinder.
Do not damage the lip of the cylinder cup.
Install the No. 2 piston with the pin hole facing upward (w/ ABS).
Push in the pistons and install a new gasket and a new piston stopper bolt (w/o ABS).
Install the straight pin with the piston pushed in (w/ ABS).
Install the straight pin correctly.
Install the snap ring using snap ring pliers with the piston pushed in.
Do not scratch the inside of the cylinder body.
47202
2.INSTALL BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY
Install the filler cap onto the brake master cylinder reservoir sub-assembly.
|
Lithium soap base glycol grease |
|
Silicon grease |
Apply lithium soap base glycol grease and silicon grease to the 2 grommets and install them onto the master cylinder body.
Install the brake master cylinder reservoir sub-assembly onto the master cylinder body.
Using a pin punch (5 mm) and hammer, tap in the ring pin.