Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE BOOSTER(for LHD)
RM19Y0E _54 Brake _002993 BRAKE SYSTEM (OTHER) _0015146 BRAKE BOOSTER(for LHD) G

BRAKE SYSTEM (OTHER)  BRAKE BOOSTER(for LHD)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 44610 1.INSPECT BRAKE BOOSTER ASSEMBLY

a.
C132722
2.417,0.125 2.906,0.583 0.49,0.458 10 *b 0.76,0.125 1.385,0.542 0.625,0.417 10 *a 0.573,1.771 0.948,2.083 0.375,0.313 10 *c 0.833,1.667 1.281,2.104 0.448,0.438 10 *d 1.115,1.542 1.51,1.875 0.396,0.333 10 *e
*a CORRECT
*b INCORRECT
*c 1st
*d 2nd
*e 3rd


Check the air tightness.

i.

Start the engine and stop it after 1 or 2 minutes. Depress the brake pedal several times slowly.

HINT:
·

If the pedal can be depressed to the floor on the 1st time, but cannot be depressed as far on the 2nd or 3rd times, the booster is airtight. If not, inspect the vacuum check valve.

·

If the vacuum check valve is normal, replace the brake booster assembly.




ii.

Depress the brake pedal while the engine is running, and stop the engine with the pedal depressed.

HINT:
·

If there is no change in the pedal reserve distance after holding the pedal for 30 seconds, the booster is airtight. If not, inspect the vacuum check valve.

·

If the vacuum check valve is normal, replace the brake booster assembly.





b.
C121844

Check the operation.

i.

Depress the brake pedal several times with the engine stopped and check that there is no change in the pedal reserve distance.


ii.

Depress the brake pedal and start the engine.

HINT:
·

If the pedal goes down slightly, the operation is normal. If not, inspect the vacuum check valve.

·

If the vacuum check valve is normal, replace the brake booster assembly.