Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE MASTER CYLINDER(for RHD) › 2011.11–2015.08
RM19Y0E _54 Brake _002993 BRAKE SYSTEM (OTHER) _0015150 BRAKE MASTER CYLINDER(for RHD) G

BRAKE SYSTEM (OTHER)  BRAKE MASTER CYLINDER(for RHD)  INSPECTION  


CAUTION / NOTICE / HINT

NOTICE:
·

The master cylinder and piston are designed so that the piston can easily fall out. Prevent this by making sure the tip of the master cylinder faces downward when handling the master cylinder.

·

Make sure foreign matter does not attach to the piston of the master cylinder. If foreign matter attaches, clean it off with a cloth. Then apply lithium soap base glycol grease to the entire outer circumference of the contact surface of the piston.



PROCEDURE

Hide 1.INSPECT AND ADJUST BRAKE BOOSTER PUSH ROD

HINT:

Adjust the booster push rod when the master cylinder is replaced with a new one. Adjustment is not necessary when the master cylinder is reinstalled and the booster is replaced with a new one.


a.
C267827
1.323,1.833 0.99,1.958 false 0.844,4 0.51,3.635 false 2.25,2.719 2.823,3.365 2.823,3.365 2.958,3.365 true 0.802,1.99 1.49,2.281 0.688,0.292 10 SST 0.167,3.552 0.854,3.844 0.688,0.292 10 SST 3.01,3.292 3.427,3.656 0.417,0.365 10 *a
*a Apply Chalk


Set SST on the master cylinder and lower the rod of SST until it touches the piston.

SST
09737-00013  

HINT:

SST 09737-00012 can also be used.



b.

Apply chalk to the flat tip of the rod of SST . Turn SST upside down and measure the clearance between the brake booster push rod and SST.

Standard clearance:

0 mm (0 in.)


If there is clearance between the main body of SST and the shell of the brake booster, the push rod is protruding too far. If the chalk does not stick to the tip of the brake booster push rod, the push rod protrusion is insufficient.


c.
C132720
1.01,0.469 0.792,0.844 0.792,0.844 0.656,0.844 false 0.323,0.76 0.906,1.104 0.583,0.344 10 SST

If the clearance is not within the standard, adjust the length by holding the rod using SST and turning the tip of the rod using a 7 mm socket driver.

SST
09737-00020  

NOTICE:

Check the push rod clearance again after adjusting.