Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE MASTER CYLINDER(for RHD) › 2011.11–2015.08
RM19Y0E _54 Brake _002993 BRAKE SYSTEM (OTHER) _0015150 BRAKE MASTER CYLINDER(for RHD) A

BRAKE SYSTEM (OTHER)  BRAKE MASTER CYLINDER(for RHD)  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

Release the vacuum from booster by depressing the brake pedal several times. Then remove the brake master cylinder sub-assembly from brake booster.


PROCEDURE

Hide 1.DRAIN BRAKE FLUID

NOTICE:

Immediately wash off any brake fluid that comes into contact with any painted surface.


Hide 31481A 2.DISCONNECT NO. 1 CLUTCH HOSE (for 3SZ-VE with Manual Transmission)

a.
C141420

Slide the clip and disconnect the clutch hose.


Hide 47201 3.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY

a.

Disconnect the brake fluid level warning switch connector.


b.
C141464

Using union nut wrench, separate the 2 brake tubes from the brake master cylinder sub-assembly.


c.
C141465

Remove the 2 nuts and remove the brake master cylinder sub-assembly.


d.

Remove the O-ring from the brake master cylinder sub-assembly.

NOTICE:
·

The master cylinder sub-assembly requires careful handling. Do not allow the master cylinder sub-assembly to receive any impact, such as from being dropped. Do not reuse a master cylinder sub-assembly that has been dropped.

·

Do not strike or pinch the master cylinder piston, and do not cause any damage to the master cylinder piston by any other means.

·

Release the vacuum from booster by depressing the brake pedal several times. Then remove the brake master cylinder sub-assembly from brake booster.

·

When installing the brake master cylinder sub-assembly onto the brake booster, or when removing the brake master cylinder sub-assembly from the brake booster, make sure that the brake master cylinder subassembly is kept horizontal or its tip faces downward (the piston faces upward) to prevent the master cylinder piston from falling off.

·

Do not allow any foreign objects to contaminate the master cylinder piston. If a foreign object gets on the piston, remove it by using a piece of cloth and then apply an even layer of lithium soap based glycol grease around the circumference (sliding part) of the piston.

·

Do not use any other type of grease or fluid.