Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE MASTER CYLINDER(for RHD) › 2011.11–2015.08
RM19Y0E _54 Brake _002993 BRAKE SYSTEM (OTHER) _0015150 BRAKE MASTER CYLINDER(for RHD) A

BRAKE SYSTEM (OTHER)  BRAKE MASTER CYLINDER(for RHD)  REASSEMBLY  


PROCEDURE

Hide 04493 1.INSTALL BRAKE MASTER CYLINDER KIT

a.

Fix the master cylinder body in a vise between aluminum plates.

NOTICE:

Do not overtighten the vise.



b.
C246225
0.594,0.625 0.896,0.625 0.896,0.625 1.125,1.083 false 2.448,1.573 2.188,1.573 2.188,1.573 2,1.167 false 1.156,1.74 0.958,1.74 0.958,1.74 0.958,1.51 false 0.406,0.542 0.938,1.104 0.531,0.563 10 *1 2.479,1.479 2.885,1.906 0.406,0.427 10 *2 1.177,1.667 1.74,2.177 0.563,0.51 10 *3
*1 Pin hole (w/ABS)
*2 No. 1 piston
*3 No. 2 piston
V100135

Lithium soap base glycol grease
V100136

Silicon grease


Apply lithium soap base glycol grease and silicon grease to the rubber part as shown in the illustration.


c.

Install the No. 1 piston and No. 2 piston onto the master cylinder body.

NOTICE:
·

Install the pistons straight while being careful not to damage the inside of the cylinder.

·

Do not damage the lip of the cylinder cup.

·

Install the No. 2 piston with the pin hole facing upward (w/ ABS).




d.
C142053

Push in the pistons and install a new gasket and a new piston stopper bolt (w/o ABS).

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


e.
C142057

Install the straight pin with the piston pushed in (w/ ABS).

NOTICE:

Install the straight pin correctly.



f.
C142052

Install the snap ring using snap ring pliers with the piston pushed in.

NOTICE:

Do not scratch the inside of the cylinder body.



Hide 47202 2.INSTALL BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY

a.

Install the filler cap onto the brake master cylinder reservoir sub-assembly.


b.
C246246
3.188,2.094 3.354,2.094 false
V100135

Lithium soap base glycol grease
V100136

Silicon grease


Apply lithium soap base glycol grease and silicon grease to the 2 grommets and install them onto the master cylinder body.


c.

Install the brake master cylinder reservoir sub-assembly onto the master cylinder body.


d.
C142051

Using a pin punch (5 mm) and hammer, tap in the ring pin.