1.REMOVE CYLINDER BOOT
| *1 | Protective tape |
Using a screwdriver with its tip wrapped in protective tape, remove the set ring and cylinder boot from the disc brake cylinder.
47731
2.REMOVE FRONT DISC BRAKE PISTON
| *1 | Cloth |
Place a piece of cloth between the front disc brake piston and disc brake cylinder.
Apply compressed air to remove the front disc brake piston from the disc brake cylinder.
Do not place your fingers in front of the front disc piston when applying compressed air.
Do not spatter the brake fluid.
3.REMOVE PISTON SEAL
| *1 | Protective tape |
Using a screwdriver with its tip wrapped in protective tape, remove the piston seal from the disc brake cylinder assembly.
Do not damage the inner surface or piston seal groove of the disc brake cylinder assembly.
31478B
4.REMOVE FRONT DISC BRAKE BLEEDER PLUG CAP
47547B
5.REMOVE FRONT DISC BRAKE BLEEDER PLUG