47547B
1.TEMPORARILY TIGHTEN FRONT DISC BRAKE BLEEDER PLUG
31478B
2.INSTALL FRONT DISC BRAKE BLEEDER PLUG CAP
3.INSTALL PISTON SEAL
|
Lithium Soap Base Glycol Grease |
Apply a light layer of lithium soap base glycol grease the entire circumference of a new piston seal as shown in the illustration.
Install the piston seal onto the disc brake cylinder assembly.
Securely install the piston seal into the groove of the disc brake cylinder assembly.
47731
4.INSTALL FRONT DISC BRAKE PISTON
|
Lithium Soap Base Glycol Grease |
Apply a light layer of lithium soap base glycol grease to the entire circumference of a new cylinder boot as shown in the illustration.
Apply a light layer of lithium soap base glycol grease to the entire circumference of the front disc brake piston as shown in the illustration.
Install the cylinder boot onto the front disc brake piston.
Install the front disc brake piston into the disc brake cylinder assembly.
Do not forcibly install the piston into the disc brake cylinder assembly.
5.INSTALL CYLINDER BOOT
| *1 | Set Ring |
| *2 | Cylinder Boot |
Install the cylinder boot into the disc brake cylinder assembly.
Securely install the cylinder boot into the groove of the disc brake cylinder assembly.
Using a screwdriver with its tip wrapped in protective tape, install a new set ring.
Do not damage the cylinder boot.
Securely install the cylinder boot into the groove of the disc brake cylinder assembly.