Home › Brake › BRAKE (REAR) › REAR BRAKE
RM19Y0E _54 Brake _002995 BRAKE (REAR) _0015155 REAR BRAKE G

BRAKE (REAR)  REAR BRAKE  INSPECTION  


PROCEDURE

Hide 42403 1.INSPECT REAR BRAKE DRUM INSIDE DIAMETER

a.
F006408
2.208,0.302 2.083,0.688 false 2.208,0.125 2.438,0.302 0.229,0.177 10 *1
*1 Brake drum gauge


Using a brake drum gauge or the equivalent, measure the inside diameter of the brake drum.

Standard inside diameter:

203 mm (7.992 in.)


Maximum inside diameter:

204 mm (8.032 in.)


If the inside diameter is greater than the maximum, replace the brake drum.


Hide 04495 2.INSPECT REAR BRAKE SHOE LINING THICKNESS

a.
C152622
0.74,0.375 0.531,0.375 0.531,0.375 0.406,0.74 false 0.781,0.292 1.031,0.521 0.25,0.229 10 *1
*1 Ruler


Using a ruler, measure the thickness of the shoe lining.

Standard thickness:

4.4 mm (0.173 in.)


Minimum thickness:

1.0 mm (0.039 in.)


If the lining thickness is equal to or less than the minimum value, or if there is any severe or uneven wear, replace the brake shoe.

NOTICE:

If the brake shoes need replacing, they must be replaced as a set.



Hide 3.INSPECT REAR BRAKE DRUM AND REAR BRAKE SHOE LINING FOR PROPER CONTACT

a.
C223521
3.094,2.083 3.302,2.083 false
V100144

Chalk


Apply chalk to the inside surface of the drum, then grind the brake shoe lining so that they fit together properly.

If the contact between the drum and the shoe lining is improper, repair it using a brake shoe grinder or replace the brake shoe assembly.


Hide 47570 4.INSPECT WHEEL BRAKE CYLINDER

a.

Check that there is no damage inside the cylinder body.

If there is any damage inside the cylinder body, replace the wheel cylinder with a new one.