Home › Brake › BRAKE (REAR) › REAR BRAKE
RM19Y0E _54 Brake _002995 BRAKE (REAR) _0015155 REAR BRAKE A

BRAKE (REAR)  REAR BRAKE  REMOVAL  


PROCEDURE

Hide 1.INSPECT REAR DRUM BRAKE SHOE LINING THICKNESS

a.
C152615
2.708,0.896 2.531,1.5 true 1.25,1.76 0.906,1.417 0.906,1.417 0.708,1.417 true 2.458,1.542 2.667,1.74 0.208,0.198 10 *1 0.521,1.354 0.74,1.531 0.219,0.177 10 *2
*1 Brake shoe
*2 Hole plug


Remove the hole plug and inspect the shoe lining thickness.

Minimum thickness:

1.0 mm (0.039 in.)


If the lining thickness is equal to or less than the minimum, replace the brake shoe. Be sure to replace both the left and right rear brake drum shoe linings at the same time (to prevent pulling).


Hide 2.REMOVE REAR WHEEL

Hide 3.DRAIN BRAKE FLUID

NOTICE:

Immediately wash off any brake fluid that comes into contact with any painted surfaces.


Hide 42403 4.REMOVE REAR BRAKE DRUM SUB-ASSEMBLY

a.

Release the parking brake and remove the rear brake drum sub-assembly.

If the rear brake drum sub-assembly cannot be removed easily, perform the following procedure.


b.
C246378
0.385,1.156 1.583,1.156 1.583,1.156 1.646,1.208 true 0.167,1.083 0.323,1.229 0.156,0.146 10 *1
*1 Automatic adjust lever
V100135

Contract


Remove the hole plug and insert a screwdriver through the hole into the backing plate, and hold the automatic adjust lever away from the adjuster.


c.

Using another screwdriver, contract the brake shoe by turning the adjusting bolt.