47643A
1.REMOVE REAR BRAKE AUTOMATIC ADJUST LEVER
Using a screwdriver, remove the automatic adjust lever support spring from the front brake shoe and the automatic adjust lever.
Remove the automatic adjust lever from the rear brake shoe.
2.REMOVE FRONT BRAKE SHOE
Using SST, remove the shoe hold down spring cup, shoe hold down spring and pin.
Do not damage the shoe hold down spring cup.
Using needle-nose pliers, remove the shoe return spring.
Remove the cylinder support spring and the front brake shoe.
47062
3.REMOVE PARKING BRAKE SHOE STRUT SET
Remove the parking brake shoe strut set from the rear brake shoe.
4.REMOVE REAR BRAKE SHOE
Using SST, remove the shoe hold down spring cup, shoe hold down spring and pin.
Do not damage the shoe hold down spring cup.
Using needle-nose pliers, disconnect the parking brake cable.
47601
5.REMOVE REAR BRAKE PARKING BRAKE SHOE LEVER SUB-ASSEMBLY
Using a screwdriver, remove the C-washer and rear brake parking brake shoe lever sub-assembly.
47548R
6.REMOVE REAR DRUM BRAKE BLEEDER PLUG CAP
47547R
7.REMOVE REAR DRUM BRAKE BLEEDER PLUG
47570
8.REMOVE REAR WHEEL BRAKE CYLINDER ASSEMBLY
Using union nut wrench, separate the brake tube from the rear wheel brake cylinder assembly.
Use a container to catch the brake fluid.
Remove the 2 bolts and remove the rear wheel brake cylinder assembly.
04474
9.REMOVE REAR WHEEL CYLINDER KIT
| *1 | Wheel cylinder boot |
| *2 | Piston |
| *3 | Wheel cylinder cup |
| *4 | Compression spring |
Remove the 2 wheel cylinder boots from the rear wheel brake cylinder assembly.
Remove the 2 pistons.
Remove the compression spring.
Remove the wheel cylinder cup from each piston.