Home › Brake › PARKING BRAKE › PARKING BRAKE SWITCH
RM19Y0E _54 Brake _002996 PARKING BRAKE _0015159 PARKING BRAKE SWITCH G

PARKING BRAKE  PARKING BRAKE SWITCH  INSPECTION  


PROCEDURE

Hide 84380 1.INSPECT BRAKE WARNING TEST SWITCH ASSEMBLY

a.

Measure the resistance between the terminal and the switch body.

Standard Resistance
Tester Connection Switch Condition Specified Condition
Terminal - Switch body ON
(Switch pin free)
Below 1 Ω
OFF
(Switch pin pushed in)
10 kΩ or higher

If the value is not as specified, replace the brake warning test switch assembly.