If a problem occurs in the electronic power steering system, the EPS warning light on the combination meter comes on, and the ECU stops the steering power assist, maintains a constant amount of power assist, or reduces the amount of power assist to protect the system.
| DTC No. | Malfunction | Fail-safe |
|---|---|---|
| C1511/11
C1512/12 C1513/13 C1514/14 C1517/17 |
Torque sensor malfunction | Power assist stopped |
| C1523/23
C1524/24 |
Motor malfunction | Power assist stopped |
| C1531/31
C1532/32 |
Power steering ECU malfunction | Power assist stopped |
| C1533/33 | Temperature sensor malfunction in power steering ECU | Assist force restricted |
| C1534/34 | EEPROM abnormal | Assist force restricted |
| C1541/41 | Vehicle speed signal | Assist force restricted |
| C1544/44 | Engine speed signal | Assist force restricted |
| C1551/51 | IG power source voltage error | Power assist stopped |
| C1552/52 | PIG power source voltage error | Power assist stopped |
| C1553/53 | Overvoltage at IG and PIG terminals | Power assist stopped |
| C1554/54 | Power source relay malfunction | Power assist stopped |
| C1555/55 | Motor relay malfunction | Power assist stopped |
| C1557/57 | Continuous Overheat Preventive Control | Power assist decrease
(not malfunction but normality) |
The amount of power assist may be decreased to prevent the motor and ECUs from overheating if the steering wheel is continuously turned when the vehicle is either stopped or driven at a low speed, or if the steering wheel is kept in either full lock position for a long time. In such cases, the amount of power assist returns to normal if the steering wheel is not turned for approximately 10 minutes with the engine idling.