Home › Steering › STEERING COLUMN › STEERING COLUMN ASSEMBLY
RM19Y0E _55 Steering _002998 STEERING COLUMN _0015163 STEERING COLUMN ASSEMBLY G

STEERING COLUMN  STEERING COLUMN ASSEMBLY  INSPECTION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for both the RHD and LHD sides.

·

The procedure described below is for the LHD side.



PROCEDURE

Hide 1.INSPECT PRELOAD

a.
C249560
1.281,1.823 2.49,1.823 true 2.563,1.74 3,2.01 0.438,0.271 10 SST

Secure the steering column assembly in a vise.

NOTICE:

When using a vise, do not overtighten it.



b.

Using SST and a torque wrench, turn the main shaft at a fixed speed between 4 to 6 seconds and measure the preload.

SST
09616-00011  

Torque:
Preload : 0.3 to 1.0 N*m (3 to 10 kgf*cm, 3 to 9 in.*lbf)

If the preload is not as specified, replace the steering column assembly.


Hide 45250 2.INSPECT STEERING COLUMN ASSEMBLY

a.
C245565
1.125,0.917 1.125,0.479 1.125,0.479 2.625,0.479 true 2.292,0.927 2.292,0.479 false 2.792,1.26 3.375,1.615 0.583,0.354 10 35mm 0.167,1.26 0.938,1.708 0.771,0.448 10 35mm 2.688,0.375 3.146,0.708 0.458,0.333 10 *1
*1 Capsule


Check that the 2 capsules are securely installed to the steering column assembly as shown in the illustration.

Standard:

35mm (1.38 in.)


NOTICE:
·

If the standard value is not satisfied, replace the steering column assembly with a new one.

·

If the capsules have deformation, damage or misalignment, replace the steering column assembly with a new one.