Home › Steering › STEERING COLUMN › STEERING COLUMN ASSEMBLY
RM19Y0E _55 Steering _002998 STEERING COLUMN _0015163 STEERING COLUMN ASSEMBLY A

STEERING COLUMN  STEERING COLUMN ASSEMBLY  DISASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for both the RHD and LHD sides.

·

The procedure described below is for the LHD side.



PROCEDURE

Hide 45020 1.REMOVE STEERING COLUMN UPPER WITH SWITCH BRACKET ASSEMBLY

a.
C147601

Using a centering punch, mark the center of the 2 tapered-head bolts.


b.

Using a 3 to 4 mm (0.12 to 0.16 in.) drill, drill a hole in the 2 bolt heads.


c.

Using a screw extractor, remove the 2 bolts and steering column upper with switch bracket assembly.


Hide 2.REMOVE IGNITION SWITCH LOCK CYLINDER ASSEMBLY

a.
C147602

Place the ignition switch lock cylinder assembly in the ACC position.


b.

Push down the stop pin with the screwdriver, and pull out the cylinder assembly.


Hide 84450 3.REMOVE IGNITION OR STARTER SWITCH ASSEMBLY (for Automatic Transaxle)

Hide 84450 4.REMOVE IGNITION OR STARTER SWITCH ASSEMBLY (for Manual Transmission)