Home › Steering › STEERING COLUMN › STEERING COLUMN ASSEMBLY
RM19Y0E _55 Steering _002998 STEERING COLUMN _0015163 STEERING COLUMN ASSEMBLY A

STEERING COLUMN  STEERING COLUMN ASSEMBLY  REASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for both the RHD and LHD sides.

·

The procedure described below is for the LHD side.



PROCEDURE

Hide 84450 1.INSTALL IGNITION OR STARTER SWITCH ASSEMBLY (for Automatic Transmission)

Hide 84450 2.INSTALL IGNITION OR STARTER SWITCH ASSEMBLY (for Manual Transmission)

Hide 3.INSTALL IGNITION SWITCH LOCK CYLINDER ASSEMBLY

a.

Make sure that the ignition switch lock cylinder assembly is in the ACC position.


b.

Install the ignition switch lock cylinder assembly.


Hide 4.INSPECT STEERING LOCK OPERATION

a.

Check that the steering lock mechanism is activated when the key is removed.


b.

Check that the steering lock mechanism is deactivated when the key is inserted and turned to the ACC position.


Hide 45020 5.INSTALL STEERING COLUMN UPPER WITH SWITCH BRACKET ASSEMBLY

a.
C147603

Temporarily install the steering column upper with switch bracket assembly and steering column upper clamp with the 2 new steering lock set bolts.


b.

Tighten the 2 tapered-head bolts until the bolt heads break off.