Home › Steering › STEERING COLUMN › STEERING WHEEL
RM19Y0E _55 Steering _002998 STEERING COLUMN _0015164 STEERING WHEEL A

STEERING COLUMN  STEERING WHEEL  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for both the RHD and LHD sides.

·

The procedure described below is for the RHD side.



PROCEDURE

Hide 45102 1.INSTALL STEERING WHEEL SUB-ASSEMBLY

a.

Align the matchmarks on the steering wheel sub-assembly and the steering main shaft assembly.


b.

Install the steering wheel sub-assembly with the set nut.

Torque:
34 N*m (350 kgf*cm, 25 ft.*lbf)


c.

Connect the connector to the spiral cable sub-assembly. (w/ Airbag System)


Hide 45130 2.INSTALL STEERING PAD (w/ Steering Pad Switch)

a.

Connect the horn terminal.


b.
C251361
2.302,0.99 2.188,0.76 true 2.708,0.781 2.854,1.094 true 2.031,0.635 2.396,0.906 0.365,0.271 10 *1 2.885,1.146 3.24,1.469 0.354,0.323 10 *2
*1 Pin
*2 Snap Ring


Engage the 3 pins with the 3 snap rings to install the steering pad.


Hide 45130 3.INSTALL STEERING PAD (w/o Steering Pad Switch)

a.

w/ Airbag System

i.

Connect the horn terminal.


ii.
C251361
2.302,0.99 2.188,0.76 true 2.708,0.781 2.854,1.094 true 2.031,0.635 2.396,0.906 0.365,0.271 10 *1 2.885,1.146 3.24,1.469 0.354,0.323 10 *2
*1 Pin
*2 Snap Ring


Engage the 3 pins with the 3 snap rings to install the steering pad.



b.

w/o Airbag system

i.

Install the wire harness to the steering pad.


ii.

Install the steering pad to the steering wheel assembly with the screw.



Hide 4.INSPECT STEERING WHEEL CENTER POINT

Hide 45130 5.INSPECT STEERING PAD

a.

With the steering pad installed to the vehicle, perform a visual check. if there are any defects as mentioned below, replace the steering pad with a new one: Cuts, minute cracks or marked discoloration on the top surface of the steering pad or in the grooved portion.


b.

Make sure that the horn sounds. If the horn does not sound, inspect the horn system.