Use the same procedure for both the RHD and LHD sides.
The procedure described below is for the RHD side.
1.PLACE FRONT WHEELS FACING STRAIGHT AHEAD
45130
2.REMOVE STEERING PAD (w/ Steering Pad Switch)
| *1 | Snap Ring |
| *2 | Protective Tape |
Using a screwdriver with its tip wrapped with protective tape, push in the 3 snap rings to disengage it from the 3 pins.
Lightly hold the steering pad to prevent it from falling.
Disconnect the horn connector.
45130
3.REMOVE STEERING PAD (w/o Steering Pad Switch)
w/ Airbag System
| *1 | Snap Ring |
| *2 | Protective Tape |
Using a screwdriver with its tip wrapped with protective tape, push in the 3 snap rings to disengage it from the 3 pins.
Lightly hold the steering pad to prevent it from falling.
Disconnect the horn connector.
w/o Airbag System
Remove the screw and separate the steering pad from the steering wheel assembly.
Remove the wire harness from the steering pad.
45102
4.REMOVE STEERING WHEEL SUB-ASSEMBLY
Disconnect the connector form the spiral cable sub-assembly. (w/ Airbag System)
| *a | Matchmark |
Remove the nut and put matchmarks on the steering wheel sub-assembly and the steering main shaft.
Using SST, remove the steering wheel sub-assembly.