Home › Steering › STEERING GEAR / LINKAGE › STEERING GEAR
RM19Y0E _55 Steering _002999 STEERING GEAR / LINKAGE _0015165 STEERING GEAR G

STEERING GEAR / LINKAGE  STEERING GEAR  INSPECTION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for both the RHD and LHD sides.

·

The procedure described below is for the LHD side.



PROCEDURE

Hide 45047 1.REMOVE TIE ROD END SUB-ASSEMBLY LH

a.
C132329

Secure the tie rod end sub-assembly LH between aluminum plates in a vise.

NOTICE:

Do not overtighten the vise.



b.

Install the nut to the stud bolt.


c.

Flip the ball joint back and forth 5 times.


d.

Set a torque wrench on the nut and check the turning torque.

Standard turning torque:

0.3 to 2.5 N*m (3 to 25 kgf*cm, 3 to 22 in.*lbf)


If the turning torque is not within the specified range, replace the tie rod end sub-assembly LH with a new one.


Hide 45046 2.REMOVE TIE ROD END SUB-ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.


Hide 3.INSPECT TOTAL PRELOAD

NOTICE:

Inspect the total preload in a no-load condition by removing the tie rod assembly RH and LH, and steering rack boots.


a.

Install SST to the pinion shaft and turn it left and right 5 times or more.

SST
09616-00011  


b.
C251054
2.799,1.027 3.104,1.18 0.305,0.153 10 SST 2.542,1.106 2.782,1.106 false

Set a torque wrench to SST and turn the pinion shaft continuously at a rate of 4 to 6 seconds per turn to inspect the total preload of the steering gear assembly.

Torque:

0.7 to 1.3 N*m (7 to 13 kgf*cm, 6 to 12 in.*lbf)


NOTICE:

Inspect the total preload around the steering rack center position.


HINT:

If total preload is not within the specified range, replace the steering gear with the new one.