Use the same procedure for both the RHD and LHD sides.
The procedure described below is for the LHD side.
44200
1.FIX POWER STEERING GEAR
| *1 | Protective Tape |
Using SST, wrapped with protection tape, secure the power steering gear in a vise.
45047
2.REMOVE TIE ROD END SUB-ASSEMBLY LH
| *a | Matchmark |
Place matchmarks on the rack end the tie rod end sub-assembly LH.
Ensure the matchmarks distinguish between RH and LH.
Remove the tie rod end sub-assembly LH and lock nut.
45046
3.REMOVE TIE ROD END SUB-ASSEMBLY RH
Use the same procedure for the RH side as for the LH side.
45535B
4.REMOVE STEERING RACK BOOT CLIP LH
Using pliers, remove the steering rack boot clip LH.
45535B
5.REMOVE STEERING RACK BOOT CLIP RH
Use the same procedure for the RH side as for the LH side.
6.REMOVE STEERING RACK BOOT CLAMP LH
Using pliers, grip the staked parts of the steering rack boot clamp LH and break them by twisting the pliers from side to side.
Remove the steering rack boot clamp LH from the rack boot.
7.REMOVE STEERING RACK BOOT CLAMP RH
Use the same procedure for the RH side as for the LH side.
45535
8.REMOVE STEERING RACK BOOT LH
45535
9.REMOVE STEERING RACK BOOT RH
45514
10.REMOVE NO. 1 STEERING RACK HOUSING BRACKET
| *a | Matchmark |
Place matchmarks on the No. 1 steering rack housing bracket and grommet.
Remove the No. 1 steering rack housing bracket and the grommet from the steering gear.
45503
11.REMOVE STEERING RACK END SUB-ASSEMBLY
Using SST, remove the steering rack end sub-assembly.
Turn SST in the directions shown in the illustration.
| *a | Turn |
| *b | Hold |
Using SST, remove the other steering rack end sub-assembly.
Turn SST in the direction shown in the illustration.
Securely hold the steering rack with SST.
Do not damage the steering rack.