Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(for Radio Receiver Type)
RM19Y0E _56 Audio / Visual / Telematics _003000 AUDIO / VIDEO _0015166 AUDIO AND VISUAL SYSTEM(for Radio Receiver Type) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio Receiver Type)  Radio Receiver Power Source Circuit  


DESCRIPTION

This circuit provides power to the stereo component tuner assembly.

WIRING DIAGRAM

E232725
3.927,2.948 5.552,3.604 1.625,0.656 10 STEREO COMPONENT TUNER ASSEMBLY 3.938,0.771 4.25,0.938 0.313,0.167 10 +B 3.927,2.781 4.24,2.948 0.313,0.167 10 E4 3.729,0.698 3.896,0.854 0.167,0.156 10 4 3.948,2.146 4.375,2.313 0.427,0.167 10 E 3.729,2.063 3.906,2.229 0.177,0.167 10 7 2.5,0.938 3.198,1.167 0.698,0.229 10 BACK UP 0.948,0.75 1.802,0.979 0.854,0.229 10 from Battery 3.948,1.427 4.26,1.594 0.313,0.167 10 ACC 3.729,1.344 3.896,1.51 0.167,0.167 10 3 2.667,1.583 3.073,1.813 0.406,0.229 10 ACC 0.542,1.406 1.802,1.635 1.26,0.229 10 from Ignition Switch

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.INSPECT POWER SOURCE CIRCUIT (STEREO COMPONENT TUNER - BODY GROUND)
a.

Disconnect the E4 stereo component tuner assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
E4-7 (E) - Body ground Always Below 1 Ω


Result:
Proceed to
OK
NG




OK

2.INSPECT POWER SOURCE CIRCUIT (POWER SOURCE)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.INSPECT POWER SOURCE CIRCUIT (POWER SOURCE)
a.
E230878
1.438,0.99 1.885,1.271 0.448,0.281 1.969,1.99 1.969,2.656 true 2.229,1.917 2.583,1.917 true 1.844,2.677 2.177,2.854 0.333,0.177 10 ACC 2.625,1.833 2.969,2.01 0.344,0.177 10 +B 1.573,1.052 1.896,1.208 0.323,0.156 10 E4 0.427,0.323 0.656,0.479 0.229,0.156 10 *a
*a Front view of wire harness connector
(to Stereo Component Tuner Assembly)


Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
E4-3 (ACC) - Body ground Ignition switch ACC 11 to 14 V
E4-4 (+B) - Body ground Always 11 to 14 V


Result:
Proceed to
OK
NG




OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR