CHECK INITIAL CHECK FUNCTION
Check the initial check function for the buzzer and sensor.
When the ignition switch is on and the shift lever in R, check that the following occurs: 1) after 0.3 seconds, the buzzer sounds for approximately 0.5 to 1.3 seconds, and 2) the system starts the obstacle detection operation.
MALFUNCTION BUZZER
Ultrasonic sensor open circuit.
If there is an open circuit between the No. 1 ultrasonic sensor and the clearance warning ECU assembly or if a sensor is malfunctioning, the malfunction is indicated as shown in the illustration.
The example shows an open circuit in the No. 1 ultrasonic sensor.
If a sensor has an open circuit, a warning indication will be displayed and the buzzer will beep. In such a case, perform inspection according to the Problem Symptoms Table.
DETECTION RANGE MEASUREMENT AND DISPLAY INSPECTION
Make sure that the parking brake is firmly applied to prevent the vehicle from moving.
Turn the ignition switch to ON.
Move the shift lever in R to check the sensors.
Move a pole around the sensor to measure the detection range of the sensor.
These detection ranges are applicable when positioning a pole with a diameter of φ60 mm (2.36 in.) parallel or perpendicular to the ground.
The ranges vary depending on the measuring method and type of obstacle (such as walls).
Back sonar sensor detection range.
| *1 | Approximately 1500 mm (59.1 in.) | - | - |
When the ultrasonic sensors have detected an obstacle, check that the buzzer sounds and indicator blinks.
| Shift Position | Buzzer Detection | Vehicle Speed |
|---|---|---|
| Back LH
Back RH |
||
| R | Sounds | - |
Check that the buzzer sounds and indicator blinks.
Buzzer sound and indicator operation will operate together.
The indicator blinks or illuminates when its related sensor detects an obstacle.
| *1 | Close-range Detection | *2 | Medium-range Detection |
| *3 | Long-range Detection | *4 | Maximum Long-range Detection |
| Detection | Distance |
|---|---|
| Close-range detection | Within 350 +/-50 mm (13.7 +/-1.96 in.) |
| Medium-range detection | 350 +/-50 to 450 +/-100 mm (13.7 +/-1.96 to 17.7 +/-3.93 in.) |
| Long-range detection | 450 +/-100 to 600 +/-100 mm (17.7 +/-3.93 to 23.6 +/-3.93 in.) |
| Maximum long-range detection | 600 +/-100 to 1500 +/-150 mm (23.6 +/-3.93 to 59.05+/-5.9 in.) |
Ultrasonic waves are used to measure the detection range. However, the detection range may vary depending on the ambient temperature.