1.INSTALL ULTRASONIC SENSOR RETAINER
| *a | Slit |
| *b | Keyhole |
When installing the retainer, align the keyhole and slit as shown in the illustration.
Engage the 4 claws and install the No. 1 ultrasonic sensor retainer to the rear bumper cover.
Use the same procedure for the RH and LH sides.
2.INSTALL NO. 1 ULTRASONIC SENSOR
Engage the 2 claws and install the No.1 ultrasonic sensor.
Use the same procedure for the RH and LH sides.
52159
3.INSTALL REAR BUMPER COVER