27370
1.INSPECT GENERATOR BRUSH HOLDER ASSEMBLY
| *a | Length |
Using a vernier caliper, measure the brush length.
10.5 mm (0.417 in.)
4.5 mm (0.177 in.)
If the brush length is less than the minimum, replace the generator brush holder assembly.
27330
2.INSPECT GENERATOR ROTOR ASSEMBLY
Check that the bearing is not rough or worn.
If necessary, replace the generator rotor assembly.
| *1 | Slip Rings |
| *2 | Ohmmeter |
Check the resistance.
Measure the resistance between the slip rings.
1.85 to 2.25 Ω at 20°C(68°F)
If the result is not as specified, replace the generator rotor assembly.
| *1 | Slip Ring |
| *2 | Ohmmeter |
| *3 | Rotor |
Measure the resistance between the slip ring and rotor core.
1 MΩ or higher
If the result is not as specified, replace the generator rotor assembly.
Check each slip ring diameter.
Check that the slip rings are not rough or scored.
If rough or scored, replace the generator rotor assembly.
| *1 | Diameter |
Using a vernier caliper, measure the slip ring diameter.
14.2 to 14.4 mm (0.559 to 0.567 in.)
14.0 mm (0.551 in.)
If the diameter is less than the minimum, replace the generator rotor assembly.