27310B
1.INSTALL GENERATOR DRIVE END FRAME BEARING
Using SST and a press, press in a new generator drive end frame bearing.
| *1 | Claw |
Align the claws of the bearing retainer with the grooves inside the generator drive end frame.
Install the bearing retainer with the 4 screws.
27330
2.INSTALL GENERATOR ROTOR ASSEMBLY
Install the generator drive end frame on the generator rotor assembly.
Do not drop the generator rotor assembly.
Install the generator rotor assembly and new washer.
27360
3.INSTALL GENERATOR COIL ASSEMBLY
| *1 | Deep Socket Wrench (21mm) |
Using a deep socket wrench (21mm) and press, slowly press in the generator coil assembly.
Install the generator coil assembly with the 4 through bolts.
27370
4.INSTALL GENERATOR BRUSH HOLDER ASSEMBLY
| *1 | Pin |
While pushing the 2 brushes to the inside of the generator brush holder assembly, insert a φ1.0 mm (0.039 in.) pin into the brush holder hole.
| *1 | Pin |
Install the generator brush holder assembly with the 2 screws.
Pull out the pin from the generator brush holder assembly.
27387
5.INSTALL TERMINAL INSULATOR
Install the terminal insulator.
27039
6.INSTALL GENERATOR REAR END COVER
Install the generator rear end cover with the 3 nuts.
27411
7.INSTALL GENERATOR PULLEY
| *a | Hold |
| *b | Turn |
Clamp the generator housing stay in a vise tightly.
Install the generator pulley onto the generator rotor shaft by tightening the generator pulley nut by hand.
Hold SST1-A with a torque wrench, and tighten SST1-B clockwise to the specified torque.
| Item | Part No. |
|---|---|
| SST 1-A and B | 09820-06010 |
| SST 2 | 09820-06021 |
Check that SST is securely fitted onto the generator rotor shaft.
Insert SST2, and engage SST2 to the pulley nut.
| *a | Hold |
| *b | Turn |
Tighten the generator pulley nut by turning SST1-A in the direction shown in the illustration.
Hold the adjustable wrench against the vise and tighten the nut securely.
Remove SST 2 from the generator assembly.
| *a | Hold |
| *b | Turn |
Hold SST1-A, Turn SST1-B, and remove SST1-A and SST1-B from the generator assembly.
Turn the generator pulley, and check that the generator pulley moves smoothly.
Remove the generator assembly from a vise.