Home › Power Source / Network › 3SZ-VE BATTERY / CHARGING › GENERATOR › 2011.11–2015.08
RM19Y0E _57 Power Source / Network _003003 3SZ-VE BATTERY / CHARGING _0015180 GENERATOR G

3SZ-VE BATTERY / CHARGING  GENERATOR  INSPECTION  


PROCEDURE

Hide 27370 1.INSPECT GENERATOR BRUSH HOLDER ASSEMBLY

a.
A118443C03
1.031,0.469 0.813,0.698 false 1.042,0.333 1.552,0.823 0.51,0.49 10 *a
*a Length


Using a vernier caliper, measure the brush length.

Standard length:

10.5 mm (0.417 in.)


Minimum length:

4.5 mm (0.177 in.)


If the brush length is less than the minimum, replace the generator brush holder assembly.


Hide 27330 2.INSPECT GENERATOR ROTOR ASSEMBLY

a.
A118444

Check that the bearing is not rough or worn.

If necessary, replace the generator rotor assembly.


b.
A118445C03
1.448,0.927 1.75,0.563 1.75,0.563 1.583,0.979 false 2.438,1.188 2.844,1.604 0.406,0.417 10 *2 1.74,0.385 2.115,0.719 0.375,0.333 10 *1
*1 Slip Rings
*2 Ohmmeter


Check the resistance.

i.

Measure the resistance between the slip rings.

Standard resistance:

1.85 to 2.25 Ω at 20°C(68°F)


If the result is not as specified, replace the generator rotor assembly.


ii.
A118446C03
0.75,1.5 0.75,0.635 true 1.771,0.583 1.542,0.969 false 0.677,1.531 1.188,1.896 0.51,0.365 10 *3 1.75,0.406 2.281,0.833 0.531,0.427 10 *1 2.438,1.188 2.865,1.615 0.427,0.427 10 *2
*1 Slip Rings
*2 Ohmmeter
*3 Rotor


Measure the resistance between the slip ring and rotor core.

Standard resistance:

1 MΩ or higher


If the result is not as specified, replace the generator rotor assembly.



c.

Check each slip ring diameter.

i.

Check that the slip rings are not rough or scored.

If rough or scored, replace the generator rotor assembly.


ii.
A118447C03
0.792,0.792 1.208,0.188 false 1.229,0.104 1.708,0.479 0.479,0.375 10 *1
*1 Diameter


Using a vernier caliper, measure the slip ring diameter.

Standard diameter:

14.2 to 14.4 mm (0.559 to 0.567 in.)


Minimum diameter:

14.0 mm (0.551 in.)


If the diameter is less than the minimum, replace the generator rotor assembly.