Home › Power Source / Network › NETWORKING › CAN COMMUNICATION SYSTEM › 2011.11–2015.08
RM19Y0E _57 Power Source / Network _003004 NETWORKING _0015181 CAN COMMUNICATION SYSTEM U

NETWORKING  CAN COMMUNICATION SYSTEM  FAIL-SAFE CHART  


FAIL-SAFE FUNCTION


a.

When communication fails in any of the CAN bus lines (communication lines), a fail-safe function(s) will operate. The fail-safe function that is specified for each system operates to prevent those systems from malfunctioning.


b.

The following table shows the effects on each system when communication is impossible. (For further details, see the pages for each system.)

Function Control Master System Related Fail-safe Operation Driver Detectable DTC Detection
(ECU that stored DTC)
ECM control ECM TCM Make the throttle angle and the engine torque a constant value. - U0100/82
(TCM)
TCM control TCM ECM When trouble is detected, shift into 3rd and then shift into the 1st to 3rd depending on the vehicle speed. - U0101
(ECM)
Meter display
·

Displays operation condition and DTCs


Combination meter assembly ECM Light does not come on, illuminates abnormally, or blinks abnormally Detectable (Abnormal display) -