Home › Vehicle Interior › DOOR LOCK › REAR DOOR LOCK
RM19Y0E _58 Vehicle Interior _003005 DOOR LOCK _0015183 REAR DOOR LOCK A

DOOR LOCK  REAR DOOR LOCK  INSTALLATION  


PROCEDURE

Hide 69740D 1.INSTALL REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY

a.

Install the rear door lock remote control cable assembly RH.


Hide 69780B 2.INSTALL REAR DOOR INSIDE LOCKING CABLE ASSEMBLY

a.

Install the rear door inside locking cable assembly RH.


Hide 69332 3.INSTALL REAR DOOR LOCK OPEN ROD

a.

Install the rear door lock open rod RH.


Hide 69340 4.INSTALL REAR DOOR LOCK ASSEMBLY

NOTICE:
·

If reusing the rear door lock assembly that has been removed, replace the door lock wire harness seal with a new seal.

·

Make sure that no grease or dirt adheres to the door lock wire harness seal surface.

·

Reusing the door lock wire harness seal or using a damaged door lock wire harness seal may cause water intrusion to the connection. This may result in a malfunction of the rear door lock assembly.



a.
B297840

Apply MP grease to the sliding parts and rotating areas of the rear door lock assembly RH.


b.
B297838

Using a "TORX" socket wrench T30, install the rear door with motor lock assembly with the 3 screws.

Torque:
5.9 N*m (60 kgf*cm, 52 in.*lbf)


c.

Connect the connector.


d.
B299133

Connect the control rod as shown in the illustration.


Hide 68104 5.INSTALL REAR DOOR GLASS SUB-ASSEMBLY

Hide 67486B 6.INSTALL REAR DOOR DIVISION BAR SEAL

Hide 67408F 7.INSTALL REAR DOOR REAR WINDOW GUIDE SUB-ASSEMBLY

Hide 67842E 8.INSTALL REAR DOOR SERVICE HOLE COVER

Hide 69206C 10.INSTALL REAR DOOR INSIDE HANDLE SUB-ASSEMBLY

Hide 67604 11.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

Hide 74640D 12.INSTALL REAR DOOR ASSIST GRIP ASSEMBLY