Home › Vehicle Interior › DOOR LOCK › BACK DOOR LOCK
RM19Y0E _58 Vehicle Interior _003005 DOOR LOCK _0015184 BACK DOOR LOCK G

DOOR LOCK  BACK DOOR LOCK  INSPECTION  


PROCEDURE

Hide 69350 1.INSPECT BACK DOOR LOCK ASSEMBLY

a.
B290800
1.729,1.135 2.438,1.615 true 1.719,2.99 2.417,3.344 true 1.375,3.979 1.021,3.635 true 1.594,3.979 1.75,3.625 true 0.302,0.073 0.906,0.729 0.604,0.656 10 *a 0.302,1.76 0.865,2.458 0.563,0.698 10 *b 0.302,3.333 0.865,4.042 0.563,0.708 10 *c 2.458,1.531 2.99,2.063 0.531,0.531 10 *1 2.479,3.24 3.146,3.896 0.667,0.656 10 *1 0.792,3.469 1.5,4.063 0.708,0.594 10 D+ 1.615,3.438 2.51,4.031 0.896,0.594 10 ACT-
*1 Striker
*a Lock
*b Unlock
*c Component without harness connected
(Back Door Lock Assembly)


Check operation of the back door courtesy switch.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
3 (ACT-) - 4 (D+) Locked 10 kΩ or higher
Unlocked Below 1 Ω


If the result is not as specified, replace the back door lock assembly.



b.
B290800
1.719,1.135 2.438,1.552 true 1.719,2.979 2.417,3.281 true 2.042,3.99 2.229,3.635 true 1.885,4.156 2.219,4.448 true 0.302,0.021 0.844,0.635 0.542,0.615 10 *a 0.302,1.698 0.865,2.219 0.563,0.521 10 *b 0.302,3.271 0.844,3.854 0.542,0.583 10 *c 2.458,1.479 3.073,1.99 0.615,0.51 10 *1 2.479,3.188 3.063,3.813 0.583,0.625 10 *1 2.25,3.479 3.01,3.99 0.76,0.51 10 U/L+ 2.271,4.375 3.219,4.667 0.948,0.292 10 LOK+
*1 Striker
*a Lock
*b Unlock
*c Component without harness connected
(Back Door Lock Assembly)


Check the operation of the back door lock motor.

i.

Apply battery voltage and check the operation of the back door motor.

OK:
Measurement Condition Specified Condition
Battery positive (+) → 2 (LOK+)
Battery negative (-) → 1 (U/L+)
Locked
Battery positive (+) → 1 (U/L+)
Battery negative (-) → 2 (LOK+)
Unlocked


If the result is not as specified, replace the back door lock assembly.