Home › Vehicle Interior › DOOR LOCK › POWER DOOR LOCK CONTROL SYSTEM › 2011.11–2015.08
RM19Y0E _58 Vehicle Interior _003005 DOOR LOCK _0015186 POWER DOOR LOCK CONTROL SYSTEM U

DOOR LOCK  POWER DOOR LOCK CONTROL SYSTEM  TERMINALS OF ECU  


CHECK DOOR CONTROL RELAY (w/o Wireless Door Lock System)


a.

Disconnect the E24 door control relay connector.

B288724
3.396,0.083 3.792,0.323 0.396,0.24 3.479,0.115 3.75,0.271 0.271,0.156 10 E24


b.

Measure the resistance and voltage according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
E24-3 (B) - Body ground R - Body ground Battery power supply Always 11 to 14 V
E24-4 (ULSW) - Body ground L - Body ground
·

Front door inside handle assembly LH (front door lock control knob LH) input*1

·

Front door inside handle assembly RH (front door lock control knob RH) input*2

·

Driver side door key-linked unlock input


·

Front door inside handle assembly LH (front door lock control knob LH) unlocked*1

·

Front door inside handle assembly RH (front door lock control knob RH) unlocked*2

·

Driver side door key cylinder in unlock position


Below 1 Ω
·

Front door inside handle assembly LH (front door lock control knob LH) locked*1

·

Front door inside handle assembly RH (front door lock control knob RH) locked*2

·

Driver side door key cylinder in neutral position


10 kΩ or higher
E24-5 (LKSW) - Body ground B - Body ground*1
V - Body ground*2
·

Front door inside handle assembly LH (front door lock control knob LH) input*1

·

Front door inside handle assembly RH (front door lock control knob RH) input*2

·

Driver side door key-linked lock input


·

Front door inside handle assembly LH (front door lock control knob LH) locked*1

·

Front door inside handle assembly RH (front door lock control knob RH) locked*2

·

Driver side door key cylinder in lock position


Below 1 Ω
·

Front door inside handle assembly LH (front door lock control knob LH) unlocked*1

·

Front door inside handle assembly RH (front door lock control knob RH) unlocked*2

·

Driver side door key cylinder in neutral position


10 kΩ or higher
E24-6 (E) - Body ground W-B - Body ground Ground Always Below 1 Ω

*1 : for LHD

*2 : for RHD


If the result is not as specified, there may be a malfunction on the wire harness side.



c.

Reconnect the E24 door control relay connector.


d.

Measure the voltage according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
E24-1 (U/L+) - Body ground P - Body ground Door lock motor unlock drive output
·

Front door inside handle assembly LH (front door lock control knob LH) locked*1

·

Front door inside handle assembly RH (front door lock control knob RH) locked*2

·

Driver side door key cylinder in neutral position


Below 1 V
·

Front door inside handle assembly LH (front door lock control knob LH) unlocked*1

·

Front door inside handle assembly RH (front door lock control knob RH) unlocked*2

·

Driver side door key cylinder in unlock position


11 to 14 V → Below 1 V
E24-2 (LOK+) - Body ground G - Body ground Door lock motor lock drive output
·

Front door inside handle assembly LH (front door lock control knob LH) unlocked*1

·

Front door inside handle assembly RH (front door lock control knob RH) unlocked*2

·

Driver side door key cylinder in neutral position


Below 1 V
·

Front door inside handle assembly LH (front door lock control knob LH) locked*1

·

Front door inside handle assembly RH (front door lock control knob RH) locked*2

·

Driver side door key cylinder in lock position


11 to 14 V → Below 1 V

*1 : for LHD

*2 : for RHD


If the result is not as specified, the door control relay may have a malfunction.




CHECK DOOR CONTROL RECEIVER (w/ Wireless Door Lock System)


a.

Disconnect the E62 door control receiver connector.

B288728
3.469,0.156 3.865,0.396 0.396,0.24 3.542,0.198 4.042,0.583 0.5,0.385 10 E62


b.

Measure the resistance and voltage according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
E62-12 (IG) - Body ground P-B - Body ground Ignition power supply Ignition switch off Below 1 V
Ignition switch ON 11 to 14 V
E62-25 (B) - Body ground B - Body ground*1
R - Body ground*2
Battery power supply Always 11 to 14 V
E62-15 (E) - Body ground W-B - Body ground Ground Always Below 1 Ω
E62-4 (CTY) - Body ground W - Body ground Door courtesy switch input All doors are closed 10 kΩ or higher
Any door is open*3 Below 1 Ω
Driver side or front passenger side door is open*4 Below 1 Ω
E62-23 (KYSW) - Body ground W-R - Body ground Unlock warning switch input No key in ignition key cylinder Below 1 V
Key inserted into ignition key cylinder 11 to 14 V
E62-6 (UKS) - Body ground L - Body ground
·

Front door inside handle assembly LH (front door lock control knob LH) input*1

·

Front door inside handle assembly RH (front door lock control knob RH) input*2

·

Driver side door key-linked unlock input


·

Front door inside handle assembly LH (front door lock control knob LH) unlocked*1

·

Front door inside handle assembly RH (front door lock control knob RH) unlocked*2

·

Driver side door key cylinder in unlock position


Below 1 Ω
·

Front door inside handle assembly LH (front door lock control knob LH) locked*1

·

Front door inside handle assembly RH (front door lock control knob RH) locked*2

·

Driver side door key cylinder in neutral position


10 kΩ or higher
E62-18 (LKS) - Body ground B - Body ground*1
V - Body ground*2
·

Front door inside handle assembly LH (front door lock control knob LH) input*1

·

Front door inside handle assembly RH (front door lock control knob RH) input*2

·

Driver side door key-linked lock input


·

Front door inside handle assembly LH (front door lock control knob LH) locked*1

·

Front door inside handle assembly RH (front door lock control knob RH) locked*2

·

Driver side door key cylinder in lock position


Below 1 Ω
·

Front door inside handle assembly LH (front door lock control knob LH) unlocked*1

·

Front door inside handle assembly RH (front door lock control knob RH) unlocked*2

·

Driver side door key cylinder in neutral position


10 kΩ or higher

*1: for LHD

*2: for RHD

*3: w/ Rear Door Courtesy Switch

*4: w/o Rear Door Courtesy Switch


If the result is not as specified, there may be a malfunction on the wire harness side.



c.

Reconnect the E62 door control receiver connector.


d.

Measure the voltage according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
E62-1 (ULM) - Body ground P - Body ground Door lock motor unlock drive output
·

Front door inside handle assembly LH (front door lock control knob LH) locked*1

·

Front door inside handle assembly RH (front door lock control knob RH) locked*2

·

Driver side door key cylinder in neutral position


Below 1 V
·

Front door inside handle assembly LH (front door lock control knob LH) unlocked*1

·

Front door inside handle assembly RH (front door lock control knob RH) unlocked*2

·

Driver side door key cylinder in unlock position


11 to 14 V → Below 1 V
E62-2 (LKM) - Body ground G - Body ground Door lock motor lock drive output
·

Front door inside handle assembly LH (front door lock control knob LH) locked*1

·

Front door inside handle assembly RH (front door lock control knob RH) locked*2

·

Driver side door key cylinder in lock position


Below 1 V
·

Front door inside handle assembly LH (front door lock control knob LH) locked*1

·

Front door inside handle assembly RH (front door lock control knob RH) locked*2

·

Driver side door key cylinder in lock position


11 to 14 V → Below 1 V
E62-21 (SPD)*3 - E62-15 (E) B-Y - W-B Vehicle speed signal Vehicle being driven at approx. 5 km/h (3 mph) Pulse generation (See waveform 1)

*1 : for LHD

*2 : for RHD

*3: w/ Theft Warning ECU Assembly


If the result is not as specified, the door control receiver may have a malfunction.



e.

Using an oscilloscope, check the waveform of the ECU.

i.
B220145
2.875,1.198 3.354,1.573 0.479,0.375 10 GND

Waveform 1

Item Content
Tester Connection E62-21 (SPD) - E62-15 (E)
Tool Setting 5 V/DIV., 100 ms./DIV.
Vehicle Condition Vehicle being driven at approx. 5 km/h (3 mph)

HINT:

The wavelength becomes shorter as the vehicle speed increases.