NOTICE WHEN CHECKING
Wireless door lock/unlock function:
The wireless door lock control function operates only when the following conditions are met:
The ignition switch is off.
All the doors are closed.
The power door lock system is functioning normally.
The operational range of the door control transmitter differs depending on the situation.
The operational range differs depending on the user, the way the door control transmitter is held and the location.
In certain areas, the operational range will be reduced due to the vehicle body shape and the influence of the surrounding environment.
The weak electric waves from the door control transmitter may be affected if the area has strong electric waves or noise. The operational range of the door control transmitter may be reduced or the door control transmitter may not function.
When the transmitter battery weakens, the operational range is reduced and the door control transmitter may not function.
If the transmitter is left in a place that is exposed to direct sunlight, such as on the instrument panel, problems, such as battery depletion, may occur.
CHECK WIRELESS DOOR LOCK CONTROL FUNCTION
The switches described below transmit signals and are built into the door control transmitter.
The operational range of the door control transmitter must be taken into account while checks are being made.
Make sure the vehicle is in a condition in which the wireless control functions can be operated (see above).
Check the basic functions:
Check that all the doors lock when the lock switch is pressed.
Check that all the doors unlock when the unlock switch is pressed.
Check the answer-back function:
When the lock switch is pressed, check that the hazard warning lights flash once simultaneously with the locking operation of all the doors.
When the unlock switch is pressed once, check that the hazard warning lights flash twice simultaneously with the unlocking operation of all the doors.
When the lock switch is pressed, check that the hazard warning lights flash once and security buzzer sounds once simultaneously with the locking operation of all the doors.
When the unlock switch is pressed once, check that the hazard warning lights flash twice and security buzzer sounds twice simultaneously with the unlocking operation of all the doors.
*: w/ Theft Warning ECU assembly
Check the illuminated entry function:
When the map light and No. 2 room light door switch is on and all the doors are locked, pressing the unlock switch causes the interior light to illuminate and driver side door to unlock simultaneously.
If the doors have not been opened, the interior light turns off in approximately 15 seconds.
Check the automatic locking function:
When all the doors are unlocked with the unlock switch, check that the doors lock again after 30*1 or 40*2 seconds when none of the following conditions are met.
None of the doors are opened.
The door control transmitter is not operated.
The driver side door lock knob is not operated.
*1: w/o Theft Warning ECU Assembly
*2: w/ Theft Warning ECU Assembly
Check the panic alarm function (w/ Theft Warning ECU Assembly):
Check that the security buzzer sounds, the hazard warning light flash, map light assembly and No. 2 room light assembly turn on for approximately 30 seconds by the theft alarm function when the lock switch is held down for 1.2 seconds or more. Also, check that the security buzzer stops sounding and the hazard warning light stop flashing, map light assembly and No. 2 room light assembly turn off when any switch of the door control transmitter is pressed or ignition switch to ON.