CHECK COMBINATION METER ASSEMBLY
Disconnect the E34 combination meter assembly connector.
Measure the voltage and resistance according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| E34-1 (L) - Body ground | W-L - Body ground | All door courtesy switches | All doors are closed | 10 kΩ or higher |
| Any door is open | Below 1 Ω | |||
| E34-16 (E) - Body ground | BR - Body ground | Ground | Always | Below 1 Ω |
| E34-30 (KEY) - Body ground | L-B - Body ground | Unlock warning switch input | No Key in ignition key cylinder | Below 1 V |
| Key inserted ignition key cylinder | 11 to 14 V | |||
| E34-39 (IG) - Body ground | R-L - Body ground | Ignition power supply | Ignition switch off | Below 1 V |
| Ignition switch ON | 11 to 14 V | |||
| E34-40 (+B) - Body ground | B-W - Body ground | Battery power supply | Always | 11 to 14 V |
If the result is not as specified, there may be a malfunction in the wire harness side.