DATA LIST
Using the intelligent tester or Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Connect the intelligent tester or Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester or Techstream on.
Enter the following menus: Body / Immobiliser / Data List.
According to the display on the intelligent tester or Techstream, read the Data List.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| +B | +B judgment | Break or Normal | Break: Battery power supply malfunctioning
Normal: Battery power supply normal |
- |
| IG SW | Ignition switch signal | OFF or ON | OFF: Ignition switch ACC or off
ON: Ignition switch ON |
- |
| Key SW | Key switch signal | OFF or ON | OFF: No key in ignition key cylinder
ON: Key inserted in ignition key cylinder |
- |
| Immobiliser | Engine immobiliser system status determined by transponder key ECU assembly | Set or Unset | Set: Engine immobiliser set (engine start prohibited [no key in ignition key cylinder])
Unset: Engine immobiliser unset (engine start permitted [key inserted in ignition key cylinder]) |
When the engine immobiliser system does not change to the unset state, this item can be used to determine if the cause is the transponder key ECU assembly. |
| Certifi Result from EFI | Certification result between the Immobiliser and EFI | Disagreement or Agreement | Disagreement: Certification codes between immobiliser and EFI did not match
Agreement: Certification codes between immobiliser and EFI matched |
- |
| Certification Request | Whether the Immobiliser transmitted the certification signal to the EFI | Not Sent or Sent | Not Sent: Certification signal was not sent
Sent: Certification signal was sent |
- |
| Key Certification Result | Immobiliser certification result to the key | Disagreement or Agreement | Disagreement: Immobiliser did not certificate the key
Agreement: Immobiliser certificated the key |
- |
| The Number of DTCs | Number of DTCs | Min.: 0, Max.: 255 | Number of stored DTCs | - |
ACTIVE TEST
Using the intelligent tester or Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Connect the intelligent tester or Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester or Techstream on.
Enter the following menus: Body / Immobiliser / Active Test.
Perform the Active Test according to the display on the intelligent tester or Techstream.
| Tester Display | Control Range | Inspection Item | Diagnostic Note |
|---|---|---|---|
| Security Indicator | ON/OFF | Security indicator light | The test is possible when the following condition is met: The key is in the ignition key cylinder. |
| Antenna Coil Power | ON/OFF | Transponder key coil | Output the electric wave from the antenna coil of the Immobiliser |