Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM › 2011.11–2015.08
RM19Y0E _58 Vehicle Interior _003006 THEFT DETERRENT / KEYLESS ENTRY _0015195 THEFT DETERRENT SYSTEM J

THEFT DETERRENT / KEYLESS ENTRY  THEFT DETERRENT SYSTEM  IG Signal Circuit  


DESCRIPTION

This circuit detects the ignition switch ON or off condition, and sends it to the door control receiver.

WIRING DIAGRAM

B298933E02
4.625,2.094 6.75,2.563 2.125,0.469 10 DOOR CONTROL RECEIVER 4.625,1.927 5.135,2.24 0.51,0.313 10 E62 4.854,1.406 5.198,1.719 0.344,0.313 10 15 5.115,1.5 5.406,1.823 0.292,0.323 10 E 4.854,0.698 5.24,0.99 0.385,0.292 10 12 5.104,0.802 5.542,1.167 0.438,0.365 10 IG 3.125,0.958 4.167,1.385 1.042,0.427 10 IG1/BACK 0.635,0.792 2.135,1.792 1.5,1 10 from Ignition or Starter Switch Assembly

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (DOOR CONTROL RECEIVER - POWER SOURCE, BODY GROUND)
B297555C02
1.49,0.052 1.979,0.344 0.49,0.292 2.458,1.083 2.458,1.833 true 0.938,1.396 0.938,1.854 true 0.885,1.896 1.281,2.125 0.396,0.229 10 E 0.167,0.146 0.563,0.5 0.396,0.354 10 *a 2.396,1.896 2.854,2.115 0.458,0.219 10 IG 1.604,0.115 2.146,0.479 0.542,0.365 10 E62
*a Front view of wire harness connector
(to Door Control Receiver)


a.

Disconnect the E62 door control receiver connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
E62-15 (E) - Body ground Always Below 1 Ω



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
E62-12 (IG) - Body ground Ignition switch ON 11 to 14 V


Result:
Proceed to
OK
NG




OK

GO TO PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR