Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM › 2011.11–2015.08
RM19Y0E _58 Vehicle Interior _003006 THEFT DETERRENT / KEYLESS ENTRY _0015195 THEFT DETERRENT SYSTEM J

THEFT DETERRENT / KEYLESS ENTRY  THEFT DETERRENT SYSTEM  Theft Warning ECU Communication Circuit  


DESCRIPTION

The theft warning ECU assembly receives signals, such as intrusion sensor invalid signal, wireless operation answer-back signal, wireless lock/unlock operation signal, panic alarm operation signal and security buzzer output signal from the door control receiver. The theft warning ECU assembly transmits the hazard warning light signal to the door control receiver.

WIRING DIAGRAM

B298508E02
4.594,1.365 7.031,1.74 2.438,0.375 10 THEFT WARNING ECU ASSEMBLY 4.594,1.198 5.042,1.5 0.448,0.302 10 J12 0.479,1.354 2.781,1.781 2.302,0.427 10 DOOR CONTROL RECEIVER 0.479,1.188 0.948,1.479 0.469,0.292 10 E62 5.354,0.469 5.792,0.802 0.438,0.333 10 RIN 5.354,0.865 5.938,1.198 0.583,0.333 10 ROUT 1.51,0.854 1.938,1.208 0.427,0.354 10 AIN 1.354,0.469 1.906,0.781 0.552,0.313 10 AOUT 5.177,0.771 5.521,1.167 0.344,0.396 10 7 5.177,0.385 5.385,0.646 0.208,0.26 10 2 1.823,0.771 2.219,1.094 0.396,0.323 10 10 1.854,0.385 2.26,0.792 0.406,0.406 10 9

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (THEFT WARNING ECU ASSEMBLY - DOOR CONTROL RECEIVER)
a.

Disconnect the E62 door control receiver connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance (Check for Open):
Tester Connection Condition Specified Condition
E62-9 (AOUT) - J12-2 (RIN) Always Below 1 Ω
E62-10 (AIN) - J12-2 (ROUT) Always Below 1 Ω


Standard Resistance (Check for Short):
Tester Connection Condition Specified Condition
E62-9 (AOUT) - Body ground Always 10 kΩ or higher
E62-10 (AIN) - Body ground Always 10 kΩ or higher


Result:
Proceed to
OK
NG




OK

PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR