1.INSTALL INTRUSION SENSOR
Install the intrusion sensor securely.
Make sure that the installation surfaces of the intrusion sensor and the No. 2 room light assembly have no damage or scratches. Presence of any damage or scratches may change the installation angle of the intrusion sensor, thus changing the detection area of the intrusion sensor. Therefore, replace the intrusion sensor and the No. 2 room light assembly as one set.
Install the intrusion sensor with the 3 screws.
Engage the 2 clamps.
Connect the connector.
2.INSTALL NO. 2 ROOM LIGHT BRACKET SUB-ASSEMBLY
81240D
3.INSTALL NO. 2 ROOM LIGHT ASSEMBLY
81241A
4.INSTALL NO. 2 ROOM LIGHT LENS