Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM › 2011.11–2015.08
RM19Y0E _58 Vehicle Interior _003007 LIGHTING (INT) _0015198 LIGHTING SYSTEM U

LIGHTING (INT)  LIGHTING SYSTEM  TERMINALS OF ECU  


CHECK DOOR CONTROL RECEIVER


a.

Disconnect the E62 door control receiver connector.

B288728
3.469,0.156 3.865,0.396 0.396,0.24 3.542,0.198 4.156,0.677 0.615,0.479 10 E62


b.

Measure the resistance and voltage according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
E62-12 (IG) - Body ground P-B - Body ground Ignition power supply Ignition switch off Below 1 V
Ignition switch ON 11 to 14 V
E62-25 (B) - Body ground B - Body ground*1
R - Body ground*2
Battery power supply Always 11 to 14 V
E62-15 (E) - Body ground W-B - Body ground Ground Always Below 1 Ω
E62-4 (CTY) - Body ground W - Body ground Door courtesy switch input All doors are closed 10 kΩ or higher
Any door is open Below 1 Ω
E62-23 (KYSW) - Body ground W-R - Body ground Key warning switch input No key in ignition key cylinder Below 1 V
Key inserted into ignition key cylinder 11 to 14 V
E62-6 (UKS) - Body ground L - Body ground
·

Front door inside handle assembly LH (front door lock control knob LH) input*1

·

Front door inside handle assembly RH (front door lock control knob RH) input*2

·

Driver side door key-linked unlock input


·

Front door inside handle assembly LH (front door lock control knob LH) unlocked*1

·

Front door inside handle assembly RH (front door lock control knob RH) unlocked*2

·

Driver side door key cylinder in unlock position


Below 1 Ω
·

Front door inside handle assembly LH (front door lock control knob LH) locked*1

·

Front door inside handle assembly RH (front door lock control knob RH) locked*2

·

Driver side door key cylinder in neutral position


10 kΩ or higher
E62-18 (LKS) - Body ground B - Body ground*1
V - Body ground*2
·

Front door inside handle assembly LH (front door lock control knob LH) input*1

·

Front door inside handle assembly RH (front door lock control knob RH) input*2

·

Driver side door key-linked lock input


·

Front door inside handle assembly LH (front door lock control knob LH) locked*1

·

Front door inside handle assembly RH (front door lock control knob RH) locked*2

·

Driver side door key cylinder in lock position


Below 1 Ω
·

Front door inside handle assembly LH (front door lock control knob LH) unlocked*1

·

Front door inside handle assembly RH (front door lock control knob RH) unlocked*2

·

Driver side door key cylinder in neutral position


10 kΩ or higher

*1 : for LHD

*2 : for RHD


If the result is not as specified, there may be a malfunction on the wire harness side.



c.

Reconnect the E62 door control receiver connector.


d.

Measure the voltage according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
E62-14 (RMLP) - Body ground W-L - Body ground Room light illumination signal
·

Room light switch is in DOOR position

·

Any door is open


11 to 14 V
·

Room light switch is in DOOR position

·

All doors are closed


Below 1 V

If the result is not as specified, the door control receiver may have a malfunction.