Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM › 2011.11–2015.08
RM19Y0E _58 Vehicle Interior _003007 LIGHTING (INT) _0015198 LIGHTING SYSTEM J

LIGHTING (INT)  LIGHTING SYSTEM  IG Signal Circuit  


DESCRIPTION

This circuit detects the ignition switch ON or off condition, and sends it to the door control receiver.

WIRING DIAGRAM

E237981E03
0.271,1.115 1.625,1.938 1.354,0.823 10 from Ignition or Starter Switch Assembly 2.844,1.323 3.75,1.781 0.906,0.458 10 IG1/BACK 4.354,2.792 6.302,3.479 1.948,0.688 10 DOOR CONTROL RECEIVER 4.479,1.01 4.865,1.375 0.385,0.365 10 12 4.792,1.156 5.167,1.51 0.375,0.354 10 IG 4.344,2.604 4.833,3.031 0.49,0.427 10 E62 4.479,1.719 4.875,2.094 0.396,0.375 10 15 4.792,1.854 5.198,2.219 0.406,0.365 10 E

CAUTION / NOTICE / HINT

HINT:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (DOOR CONTROL RECEIVER - POWER SOURCE, BODY GROUND)
B297555C01
1.354,0.188 1.844,0.438 0.49,0.25 0.948,1.813 0.948,1.396 true 2.458,1.771 2.458,1.094 true 1.469,0.229 1.927,0.615 0.458,0.385 10 E62 0.146,0.115 0.458,0.417 0.313,0.302 10 *a 0.917,1.833 1.208,2.146 0.292,0.313 10 E 2.427,1.802 2.896,2.125 0.469,0.323 10 IG
*a Front view of wire harness connector
(to Door Control Receiver)


a.

Disconnect the E62 door control receiver connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
E62-15 (E) - Body ground Always Below 1 Ω



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
E62-12 (IG) - Body ground Ignition switch ON 11 to 14 V


Result:
Proceed to
OK
NG




OK

GO TO PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR