81260A
1.INSPECT MAP LIGHT ASSEMBLY
Check the light operation.
| *a | Component without harness connected
(Map Light Assembly) |
Apply battery voltage to the terminals and check that the light comes on.
| Measurement Connection | Switch Condition | Specified Condition |
|---|---|---|
| Battery positive (+) - 3 (+)
Battery negative (-) - 1 (-) |
OFF | Light not come on |
| Battery positive (+) - 3 (+)
Battery negative (-) - 2 (DR) |
OFF | Light not come on |
| Battery positive (+) - 3 (+)
Battery negative (-) - 2 (DR) |
DOOR | Light come on |
| Battery positive (+) - 3 (+)
Battery negative (-) - 1 (-) |
ON | Light come on |
If the result is not as specified, replace the map light assembly.