Home › Vehicle Interior › LIGHTING (INT) › PERSONAL LIGHT(w/ Glass Case)
RM19Y0E _58 Vehicle Interior _003007 LIGHTING (INT) _0015203 PERSONAL LIGHT(w/ Glass Case) G

LIGHTING (INT)  PERSONAL LIGHT(w/ Glass Case)  INSPECTION  


PROCEDURE

Hide 81260A 1.INSPECT MAP LIGHT ASSEMBLY

a.
E145548
0.865,1.313 1.229,1.958 true 2.188,2.333 2.448,2.771 true 0.333,0.271 0.771,0.635 0.438,0.365 10 *a 2.521,2.677 2.844,3.01 0.323,0.333 10 - 0.719,1.177 1.073,1.531 0.354,0.354 10 +
*a Component without harness connected
(Map Light Assembly)


Check the map light assembly operation (Push Switch).

i.

Apply battery voltage to the terminals and check that the light comes on.

Result:
Measurement Connection Switch Condition Specified Condition
Battery positive (+) - 6 (+)
Battery negative (-) - 7 (-)
OFF All light not come on
Battery positive (+) - 6 (+)
Battery negative (-) - 7 (-)
LH Side Switch ON LH Side light come on
Battery positive (+) - 6 (+)
Battery negative (-) - 7 (-)
RH Side Switch ON RH Side light come on


HINT:

If the result is not as specified, replace the map light assembly.




b.
E145548
0.865,1.313 1.229,1.958 true 2.396,1.302 2.167,1.958 true 0.333,0.292 0.729,0.635 0.396,0.344 10 *a 0.688,1.219 1.01,1.542 0.323,0.323 10 + 2.448,1.219 3,1.573 0.552,0.354 10 DR
*a Component without harness connected
(Map Light Assembly)


Check the map light assembly operation (Slide Switch).

i.

Apply battery voltage to the terminals and check that the light comes on.

Result:
Measurement Connection Switch Condition Specified Condition
Battery positive (+) - 6 (+)
Battery negative (-) - 1 (DR)
OFF All light not come on
Battery positive (+) - 6 (+)
Battery negative (-) - 1 (DR)
DOOR All light comes on


HINT:

If the result is not as specified, replace the map light assembly.