Home › Vehicle Interior › LIGHTING (INT) › ROOM LIGHT(w/ Intrusion Sensor)
RM19Y0E _58 Vehicle Interior _003007 LIGHTING (INT) _0015204 ROOM LIGHT(w/ Intrusion Sensor) G

LIGHTING (INT)  ROOM LIGHT(w/ Intrusion Sensor)  INSPECTION  


PROCEDURE

Hide 81250 1.INSPECT NO. 2 ROOM LIGHT ASSEMBLY

a.

Check the light operation.

i.
E238780
1.75,0.938 2.052,0.938 true 1.729,1.115 1.729,1.417 true 2.938,1.51 2.698,1.906 true 0.177,0.125 0.604,0.531 0.427,0.406 10 *a 2.094,0.844 2.594,1.26 0.5,0.417 10 CRL 2.969,1.417 3.396,1.74 0.427,0.323 10 *1 1.635,1.427 2.208,1.823 0.573,0.396 10 +B
*1 Intrusion Sensor
*a Component without harness connected
(No. 2 Room Light Assembly)


Apply battery voltage to the terminals and check that the light comes on.

Result:
Measurement Connection Switch Condition Specified Condition
Battery positive (+) - 4 (+B)
Battery negative (-) - 1 (CRL)
OFF Light not come on
Battery positive (+) - 4 (+B)
Battery negative (-) - 1 (CRL)
DOOR Light come on




b.

Disconnect the intrusion sensor connector.


c.
E238781
1.521,1.281 1.521,0.469 1.521,0.469 1.74,0.469 true 1.031,3.229 1.031,2.531 1.031,2.531 1.26,2.531 true 1.521,1.396 1.521,2.208 1.521,2.208 1.74,2.208 true 0.135,0.135 0.51,0.417 0.375,0.281 10 *a 1.802,0.375 2.156,0.708 0.354,0.333 10 1 1.802,2.135 2.052,2.375 0.25,0.24 10 2 1.323,2.438 1.719,2.813 0.396,0.375 10 *b
*a Component without harness connected
(No. 2 Room Light Assembly)
*b Ground


Apply battery voltage to the terminals and check that the light comes on.

Result:
Measurement Connection Switch Condition Specified Condition
Battery positive (+) - 2
Battery negative (-) - 1
OFF Light not come on
Battery positive (+) - 2
Battery negative (-) - Ground
OFF Light not come on
Battery positive (+) - 2
Battery negative (-) - 1
DOOR Light come on
Battery positive (+) - 2
Battery negative (-) - Ground
ON Light come on


If the results are not as specified, replace the No. 2 room light assembly.