Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM › 2011.11–2015.08
RM19Y0E _58 Vehicle Interior _003008 METER / GAUGE / DISPLAY _0015206 METER / GAUGE SYSTEM J

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  Entire Combination Meter does not Operate  


DESCRIPTION

This circuit provides power to the combination meter assembly.

WIRING DIAGRAM

E230927E05
4.771,3.969 6.885,4.552 2.115,0.583 10 Combination Meter Assembly 4.771,3.792 5.333,4.135 0.563,0.344 10 E34 5.594,1.188 6.167,1.615 0.573,0.427 10 IG 5.292,1.094 5.813,1.479 0.521,0.385 10 39 5.594,2.063 5.938,2.448 0.344,0.385 10 +B 5.292,1.969 5.781,2.354 0.49,0.385 10 40 5.594,2.927 6.042,3.354 0.448,0.427 10 E 5.292,2.833 5.74,3.167 0.448,0.333 10 16 4,1.354 4.958,1.896 0.958,0.542 10 ECU IG2 1.125,1.177 2.573,2 1.448,0.823 10 from Ignition or Starter Switch Assembly 2.875,2.219 4.01,2.75 1.135,0.531 10 BACK UP 0.521,2.042 2.135,2.708 1.615,0.667 10 from Battery

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - BATTERY AND BODY GROUND)
E208723C02
1.469,0.177 1.958,0.469 0.49,0.292 2.396,1.135 2.771,0.542 true 2.75,1.313 2.031,1.74 true 2.875,1.313 2.917,1.771 true 0.115,0.073 0.49,0.406 0.375,0.333 10 *a 1.594,0.24 2.094,0.521 0.5,0.281 10 E34 2.781,0.281 3.208,0.75 0.427,0.469 10 E 1.844,1.719 2.219,2.052 0.375,0.333 10 IG 2.854,1.781 3.281,2.104 0.427,0.323 10 +B
*a Front view of wire harness connector
(to Combination Meter Assembly)


a.

Disconnect the E34 combination meter assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
E34-39 (IG) - Body ground Ignition switch ON 11 to 14 V
E34-40 (+B) - Body ground Always 11 to 14 V



c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
E34-16 (E) - Body ground Always Below 1 Ω


Result:
Proceed to
OK
NG




OK

REPLACE COMBINATION METER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR