Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM › 2011.11–2015.08
RM19Y0E _58 Vehicle Interior _003008 METER / GAUGE / DISPLAY _0015206 METER / GAUGE SYSTEM D

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  DTC CHECK / CLEAR  


CHECK DTC


F100115N07
1.594,0.333 1.594,0.781 true 1.823,1.469 1.823,1.823 true 1.552,0.104 2,0.552 0.448,0.448 10 E 1.656,1.865 2.51,2.146 0.854,0.281 10 ECUT

a.

Using SST, connect terminals 13 (ECUT) and 4 (E) of the DLC3.

SST
09843-18040  

NOTICE:
·

Always use the specified SST to connect terminals of the DLC3.

·

If the connecting position is wrong, trouble occurs.

·

Perform the check with the vehicle stopped.




b.

Turn the ignition switch to ON and start the check.

HINT:

When two or more DTC are stored in the memory, DTCs will be displayed in ascending numerical order, and repeats from the first one 4 seconds after indicating the last one.



c.

After checking the DTC, remove SST from the DLC3.

HINT:
·

If no DTCs or no normal display are shown, there may be an open circuit between the DLC3 and the combination meter, or in the diagnosis communication lines, or be a malfunction in the combination meter.

·

If any unknown DTCs are output, there may be a malfunction in the computer.





CLEAR DTC


a.

Disconnect the battery cable for 60 seconds or more.