Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM › 2011.11–2015.08
RM19Y0E _58 Vehicle Interior _003008 METER / GAUGE / DISPLAY _0015206 METER / GAUGE SYSTEM J

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  Engine Coolant Temperature Receiver Gauge Malfunction  


DESCRIPTION

The combination meter assembly controls the engine coolant temperature receiver gauge in accordance with engine coolant temperature signals from the engine coolant temperature sensor or water temperature sender gauge.

WIRING DIAGRAM

E230924E03
4.875,2.438 5.375,2.854 0.5,0.417 10 E34 4.875,2.604 7.031,3.052 2.156,0.448 10 Combination Meter Assembly 5.146,1.146 5.573,1.51 0.427,0.365 10 + 4.885,1.063 5.365,1.542 0.479,0.479 10 20 1.802,1.552 2.542,1.958 0.74,0.406 10 C15 1.802,1.74 4.469,2.302 2.667,0.563 10 Engine Coolant Temperature Sensor 3.521,1.052 3.917,1.438 0.396,0.385 10 3

PROCEDURE

1.INSPECT COMBINATION METER ASSEMBLY (ENGINE COOLANT TEMPERATURE SENSOR)
E204584C02
0.49,0.771 0.979,1.063 0.49,0.292 0.125,0.104 0.51,0.583 0.385,0.479 10 *a 0.604,0.833 1.229,1.188 0.625,0.354 10 C15
*a Front view of wire harness connector
(to Engine Coolant Temperature Sensor)


a.

Disconnect the C15 engine coolant temperature sensor connector.


b.

Turn the ignition switch to ON, and then check the position of the receiver gauge needle.

OK:

Needle position is on COOL.



c.

Connect the terminal 3 (+) and body ground on the wire harness side connector of the engine coolant temperature sensor.


d.

Turn the ignition switch to ON, and then check the position of the receiver gauge needle.

OK:

Needle position is on HOT.


Result:
Proceed to
OK
NG




OK

2.CHECK HARNESS AND CONNECTOR (COMBINATION METER - ENGINE COOLANT TEMPERATURE SENSOR)

NG

REPLACE COMBINATION METER ASSEMBLY

2.CHECK HARNESS AND CONNECTOR (COMBINATION METER - ENGINE COOLANT TEMPERATURE SENSOR)
a.

Disconnect the E34 combination meter assembly connector.


b.

Disconnect the C15 engine coolant temperature sensor connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance (Check for Open):
Tester Connection Condition Specified Condition
E34-20 (+) - C15-3 Always Below 1 Ω


Standard Resistance (Check for Short):
Tester Connection Condition Specified Condition
E34-20 (+) - Body ground Always 10 kΩ or higher


Result:
Proceed to
OK
NG




OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR