Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM › 2011.11–2015.08
RM19Y0E _58 Vehicle Interior _003008 METER / GAUGE / DISPLAY _0015206 METER / GAUGE SYSTEM C

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  0051  Lost Communication with ECM  0052  Lost Communication with TCM  0053  Lost Communication with Anti-lock Brake System (ABS) Control Module  0054  Lost Communication with Power Steering Control Module  


DESCRIPTION

·

0051: The combination meter assembly receives signals from the ECM through the CAN communication lines.

·

0052: The combination meter assembly receives signals from the TCM through the CAN communication lines.

·

0053: The combination meter assembly receives signals from the skid control ECU assembly through the CAN communication lines.

·

0054: The combination meter assembly receives signals from the power steering ECU assembly through the CAN communication lines.


DTC No. Detection Item DTC Detection Condition Trouble Area
0051 Lost Communication with ECM The combination meter assembly does not receive data from the ECM.
·

CAN communication system

·

ECM

·

Combination meter assembly


0052 Lost Communication with TCM The combination meter assembly does not receive data from the TCM.
·

CAN communication system

·

TCM

·

Combination meter assembly


0053 Lost Communication with Anti-lock Brake System (ABS) Control Module The combination meter assembly does not receive data from the skid control ECU assembly.
·

CAN communication system

·

Skid control ECU assembly

·

Combination meter assembly


0054 Lost Communication with Power Steering Control Module The combination meter assembly does not receive data from the power steering ECU assembly.
·

CAN communication system

·

Power steering ECU assembly

·

Combination meter assembly



PROCEDURE

1.CHECK DTC OUTPUT
a.

If the DTCs related to CAN communication are output, refer to "HOW TO PROCEED WITH TROUBLESHOOTING" in the CAN communication system.

Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING

Using SST, connect terminals 13 (ECUT) and 4 (E) of the DLC3.


SST
09843-18040  

b.

Turn the ignition switch to ON and start the check.

Result:
Result Proceed to
DTC output A
No DTC output B




A

B