Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › STEERING PAD
RM19Y0E _58 Vehicle Interior _003010 SUPPLEMENTAL RESTRAINT SYSTEMS _0015208 STEERING PAD A

SUPPLEMENTAL RESTRAINT SYSTEMS  STEERING PAD  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 45130 3.REMOVE STEERING PAD ASSEMBLY

a.
B296827C01
0.448,2.354 0.729,2.51 true 1.635,2.542 1.885,2.302 true 2.802,2.594 3.052,2.354 true 0.271,2.26 0.458,2.417 0.188,0.156 10 *1 1.917,2.229 2.104,2.385 0.188,0.156 10 *1 3.083,2.26 3.271,2.417 0.188,0.156 10 *1
*1 Spring


Using a screwdriver, push in the 3 springs to detach the 3 pins.

NOTICE:

Do not drop the steering pad assembly.



b.

Pull out the steering pad assembly from the steering wheel assembly and support the steering pad assembly with one hand.

NOTICE:

When removing the steering pad assembly, do not pull the airbag wire harness.



c.
B296828C01
0.844,2.656 1.458,3.052 true 1.49,2.948 1.677,3.104 0.188,0.156 10 *1
*1 Locking Button


Pull the locking button to release the connector lock.


d.

Disconnect the airbag connector from the steering pad assembly.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.



e.

Disconnect the horn wire harness connector from the steering pad contact plate and remove the steering pad assembly.

CAUTION:

When storing the steering pad assembly, keep the airbag deployment side facing upward.