Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT AIRBAG SENSOR › 2011.11–2015.08
RM19Y0E _58 Vehicle Interior _003010 SUPPLEMENTAL RESTRAINT SYSTEMS _0015212 FRONT AIRBAG SENSOR A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT AIRBAG SENSOR  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 89173 2.REMOVE FRONT AIRBAG SENSOR

a.
B296849

Remove the 2 bolts and front airbag sensor.


b.

Disengage the clamp.


c.

Disconnect the sensor connector from the front airbag sensor.

i.

Push the connector lock lever (white colored) to release the connector lock and disconnect the sensor connector (yellow colored) from the front airbag sensor.

H103033C01
1.344,0.417 1.417,0.167 1.417,0.167 2,0.167 false 0.292,1.167 0.292,1.5 0.292,1.5 0.417,1.5 false 4.073,0.531 4.167,0.167 4.167,0.167 4.5,0.167 false 4.354,0.844 4.667,0.583 4.667,0.583 5.083,0.583 true 3.417,1.667 3.833,1.667 3.833,1.667 3.917,1.396 false 2.083,0.083 2.396,0.281 0.313,0.198 10 *1 4.583,0.083 4.74,0.281 0.156,0.198 10 A 5.167,0.51 5.479,0.708 0.313,0.198 10 *1 0.49,1.417 0.802,1.615 0.313,0.198 10 *3 3.219,1.583 3.531,1.781 0.313,0.198 10 *2
*1 Connector Lock Lever (White Colored) *2 Sensor Connector (Yellow Colored)
*3 Front Airbag Sensor - -


NOTICE:
·

Do not push the part of the connector housing labeled A when disconnecting the sensor connector.

·

When handling the sensor connector, take care not to damage the sensor wire harness.




ii.

Check that the terminal housing is in the unlock position.

H103032C01
1.938,1.333 2.188,1.333 2.188,1.333 2.188,1.083 true 2.542,1.333 2.292,1.333 2.292,1.333 2.292,1.021 true 5.667,1.25 5.833,1.25 5.833,1.25 5.833,0.896 true 6.333,0.25 6.5,0.167 6.5,0.167 6.667,0.167 false 1.917,2.583 2.25,2.583 2.25,2.583 2.25,2.417 true 2.667,2.615 2.417,2.615 2.417,2.615 2.417,2.365 true 5.75,2.583 5.917,2.583 5.917,2.583 5.917,2.198 true 6.073,1.583 6.083,1.333 6.083,1.333 6.333,1.333 false 1,0.417 1.313,0.615 0.313,0.198 10 *a 4.417,0.417 4.729,0.615 0.313,0.198 10 *a 1,1.833 1.313,2.031 0.313,0.198 10 *b 4.417,1.833 4.75,2.083 0.333,0.25 10 *b 1.75,1.25 2.063,1.448 0.313,0.198 10 *1 2.583,1.25 3.083,1.448 0.5,0.198 10 *2 (*c) 5.25,1.188 5.698,1.417 0.448,0.229 10 *2 (*c) 6.74,0.083 7.052,0.281 0.313,0.198 10 *1 6.417,1.25 6.729,1.448 0.313,0.198 10 *1 1.667,2.51 1.979,2.708 0.313,0.198 10 *1 2.75,2.563 3.25,2.75 0.5,0.188 10 *2 (*d) 5.333,2.5 5.833,2.75 0.5,0.25 10 *2 (*d)
*1 Connector Housing *2 Terminal Housing
*a Incorrect *b Correct
*c Lock Position *d Unlock Position